starter and motor connections

(1) starter 6 coil 12 heads, in internal have fixed connection, with only six wiring pillar out as the rotor in connection with

the line;
(2) connection scheme: starter terminals, CC pressure in the third terminals;
(3) as the starter has instead of the original rotor external the secondary circuit system, so the secondary circuit system

doesn't work, it will be time relay cut off power supply into line, the original secondary loop system is no longer action.
4, commissioning
(1) the installation is completed, the user to
rotating joint the starter, the transmission equipment, control box checking, indeed, to be

(assembly with 500 V ZhaoOuBiao after the reason about not less than 1 M Ω), jammed, poor contact fault can start;
(2) such as the discovery of starting trip, can be appropriately will over-current protection up some, or will delay the time a

little longer;
(3) the motor parameter is different, the product installation, operation with the original work compared to the current way

in-3% range are is a normal phenomenon;
(4) starters because do not need resection, and participate in the rotor operation, the boat is a little temperature is a normal

phenomenon, its temperature rise and motor insulation class B standard the same temperature. Such as high temperature, should

stop checking reason, whether sequence meets wrong (or exchange regulator and a multimeter ac voltage file test sequence), or

pressure by bad;
5, starters to rotary union unload and maintenance
(1) the external six terminals and rotor six lines must add the pad pressed by firm, if should be tightened loose, best monthly

checks whether a loose;
(2) starter internal six coil connected, the factory has pressure, but the long-term operation, also may loose, every half year

should also check whether a loose, if it can be first loose rotor six grounded thrum, then use the plum flower board gloves live

inside the changing a nut, with a screwdriver or tools such as against the screw sunken mouth, use spanner from outside the nut

tighten the fastening terminals, be careful not to damage the line bag;
(3) starters generally do not split up, because the factory, has adjusted to the best place. If one thousand six coil loose

bands, must open the yoke board to fiber optic rotary joint
internal six terminal pressures, can be removed for a sign in one position original set of in

situ mount. Check whether recovery, can at assembly observe whether core gave in good joint tight.
6, WSBQ-II brush less variable resistance starter advantages
(1) check cost reduced. The original every time stop kiln overhaul, check the fan for part of the total carbon brush, brush the

compression spring, wearing, plus the peacetime change time relay, middle relays, ac contactor, each motor check every year with

spare parts, materials average about 4000 yuan. Now the branchless variable resistance starter meet and rotor lead series,

reduce the secondary circuit and carbon brush components, and branchless variable resistance starter is out of the commissioning

has the best condition, so usually just check whether terminals, become loose, labor intensity of the workers also greatly to

reduce.
(2) starting, smooth operation. In a year, the fan smooth operation, start flowing, can meet the required starting torque.

Starting time of 13.8, reduce the current round of resistance to blunt time, no effect on production and the operation of

equipment.
After nearly a year of the time trial run, WSBQ-II branchless variable resistance started in the trial of the machine of smooth

operation, saving JianXiuFei, which can be used.