Improvement scheme

For the few movement part of subject matter, with servo control system instead of the original cylinder, system control mode is shown below
1. Control instructions
Use touch screen will each servo motion parameters (speed, position) write PLC, again by PLC through the operation and logic control through the communication of each servo system for sequence control. All the steps can manually process completed, also can be done automatically.
rotary union
2. After the improvement advantage
Using the above motor respectively of the original cylinder and replace manual adjustment device, at the same time, the Kinco servo with the communication function make the touch screen to control PLC, again let PLC through the communication to rotary joints control servo motor speed and feeding.
In the improvement is all by cylinder control before, now marked with servo control. Performance by the following will add, improve.
Three, summarizes
The woodworking machinery through the application of Kinco servo motor communication function, the quantity and the equipment PLC the number of IO mouth greatly reduce. At the same time and with the same kind of impulsive control servo system compared to, not only in the cost has been saved. At the same time also can be through the Kinco servo internal programming function, to the simplified PLC programming, there are a lot of help.
The performance of the woodworking machinery is concerned, the application of the servo motor in addition to
fiber optic rotary joint the above performance advantages besides, still added milling party slots, milling deep slot and so on the process. With the processing technology of the door plank and woodworking machinery process requirement rise ceaselessly, the development of equipment for the future and excellent expansibility.